How to use Descriptive Statistics Calculator
- Paste the numbers into Numbers to summarize, one per entry.
- Leave How the numbers are separated on Detect from the text, or pick your separator.
- Set the decimal places. The summary updates as you change the numbers.
- If an entry cannot be read, its position is named so you can fix it.
Example: Descriptive Statistics Calculator
Summarize the values 2, 4, 4 and 6.
Options
- How the numbers are separated
- Detect from the text counts commas, semicolons, tabs and line breaks and takes the one that appears most often; when none appear, spaces separate values.
- Numbers to summarize
- One number per entry. A blank line is ignored and counted rather than read as zero.
- Decimal places
- 0, 2, 4, 6 or 8. The table rounds at this precision while the values are held at 80 significant digits underneath.
Supported inputs and limits
- Up to 10,000 numbers and 200,000 characters per run, with at most 80 significant digits per number and a decimal exponent from -999 to 999.
- Write decimal points and no thousands separators: use 1000 for one thousand.
- In comma mode, 1,000 becomes two entries; in a line-based mode it may be rejected.
- An unreadable entry stops the summary and is named by position.
- Quartiles use type 7 linear interpolation between sorted observations, so another calculator’s quartile rule can differ.
More details
Both population and sample spread are listed; sample spread needs at least two observations.
This summarizes one list, without weights, group comparisons or hypothesis tests.
Where your input is processed
This tool does not upload your inputs. See the limits for anything saved on your device.
Mean and median react differently
The mean uses each value’s magnitude, while the median depends on the middle position after sorting. For 1, 2, 3, 4 and 100, the mean is 22 and the median is 3. Changing 100 to 1,000 moves the mean to 202 but leaves the median at 3. Compare both with the full list; a wide range alone does not establish that a value is an error or an outlier.
What the mode is for
The mode is the numeric value that appears most often in the list. Numbers that never repeat give no mode, and the page says so instead of picking one, while ties are reported in value order.
Questions about Descriptive Statistics Calculator
Why does the result say there is no mode?
A mode is a value that repeats. In 1, 2, 3 every value appears once, so there is none. Ties for the highest count are all listed.
Is an empty line treated as zero?
No. Blank lines are ignored and their count appears under the table. Zero has to be typed as 0.
Why was 1,000 split into two numbers?
When commas are the selected or detected separator, 1,000 reads as two entries, 1 and 000. Use 1000 for one thousand. Other separator modes do not make thousands separators valid.
Which should I read, the mean or the median?
Both. For 1, 2, 3, 4 and 100 the mean is 22 and the median is 3, because one large value moves the mean much further than the middle position.