How to use Stereo Channel Splitter and Router
- Choose supported mono or stereo audio and listen to the source.
- Choose a Channel output mode that matches its channel count. For Stereo: map left and right, set Stereo output left and Stereo output right to original left, original right or silence.
- Process and check both sides of a stereo result. In split mode, audition the first mono file here and open the second download separately.
- Download the WAV files and stereo-routing-report.json. Splitting retains separate signals; stereo-to-mono averaging can cancel opposite-phase sound.
Example: Stereo Channel Splitter and Router
Separate two different test tones.
Options
- Channel output
- Split produces two mono files. Mapped stereo selects original left, original right or silence independently for each output side.
Supported inputs and limits
- Supported PCM WAV retains its 8–96 kHz mono/stereo layout.
- Other admitted audio decodes at 48 kHz with browser-dependent codec support.
- Up to 128 MiB, 600 seconds and 256 MiB of decoded samples; out-of-range samples are refused.
- Split, map, swap and average require stereo; duplication requires mono.
- Averaging opposite-phase sound may cancel it.
More details
Exports are PCM16 WAV without source tags.
No MP3 encoder or multichannel routing.
Work stays on your device.
Where your input is processed
This tool does not upload your inputs. See the limits for anything saved on your device.
Routing is a selection, not a stereo repair
Each output channel can use original left, original right or silence. Mapping left to both sides creates dual mono; it does not recover information missing from the right side. Swapping channels changes their placement without correcting phase, balance or microphone timing.
Review the second download too
The audition control plays the first rendered WAV. In split mode, open the second file separately to check the other channel. Both outputs preserve the input sample rate and duration, while their sample precision is reduced to PCM16.
Questions about Stereo Channel Splitter and Router
Does splitting combine the two signals?
No. Each mono download takes one original channel. To copy one channel of a stereo source into both output sides, choose mapped stereo. For a mono source, use Mono to stereo: copy to both channels.
Can I listen to both split files on this page?
The audition control plays the first rendered file. Open the second download separately to check its channel.
Is my input uploaded?
Nothing is uploaded.