How to use Tile and Flooring Planner
- Choose one length unit and enter each independent room section as name | length | width | count. Use usable dimensions after any perimeter expansion allowance.
- Enter material length, width and the gap between neighboring pieces in the same unit. Changing units does not convert numbers.
- Choose fixed orientation or compare both whole-grid orientations for each section. The comparison does not rotate individual cells.
- Set extra pieces for breakage and pieces per pack. Calculate and inspect each grid, edge cut sizes and whole-pack total.
- Download calculation.csv and layout-plan.json if needed. Allow separately for patterns, staggered joints and any cut-off reuse you intend.
Example: Tile and Flooring Planner
A 4 by 3 meter kitchen using 0.6 by 0.3 meter pieces with a 0.003 meter joint gap.
Supported inputs and limits
- Up to 100 sections in at most 100,000 characters and 250,000 grid cells per section.
- Use positive plain-decimal room/material dimensions and a nonnegative joint gap.
- Extra pieces are 0% to 100%; pack size is a positive whole number.
- Grids start at a corner, with gaps only between pieces.
- Every occupied cell consumes a piece, without offcut reuse within or between rooms.
More details
Extra stock is added after grid counts, then packs round up.
Overlapping room sections are not deducted automatically.
Diagonal, staggered and pattern-matching layouts are unsupported.
Where your input is processed
This tool does not upload your inputs. See the limits for anything saved on your device.
Questions about Tile and Flooring Planner
Are offcuts reused in other cells?
No. Each occupied grid cell consumes a new piece. The planner reports a conservative straight-grid count without offcut reuse.
What does the orientation choice change?
It compares the two whole-grid orientations for each section and chooses the one needing fewer pieces before extra stock. It does not rotate individual cells.
Do joints count at the room edges?
Only gaps between neighboring pieces are included. Perimeter expansion gaps must already be removed from your usable room dimensions.