Drywall and Stud Material Planner

Lay out drywall cells and stud segments around entered rectangular openings in a single wall.

On-device No sign-up Free to use

Plan wall materials controls

Showing an example. Edit to see your own.

?

All dimensions use this unit. Re-enter dimensions and any area-based coverage when changing units.

?

?

?

?

?

?

?

?

Optional; up to 40 non-overlapping rectangular openings. Coordinates start at the lower left of the wall.

?

Processed in your browser. Your inputs stay on this device.

Result

Showing an example.

A 4.8 by 2.4 meter wall with one 0.8 meter-wide floor-level opening and 0.4 meter stud spacing.

5 sheets and 13 stud stock pieces

https://usefreetools.net/drywall-stud-material-planner · 20 November 2026

Was this helpful?

How to use Drywall and Stud Material Planner

  1. Choose one length unit, then enter wall size, sheet size, stud center spacing and stock length. Changing the unit does not convert existing numbers.
  2. Optionally enter openings as x | y | width | height, one per line. The origin is the wall’s lower-left corner; openings must fit and must not overlap.
  3. Set the layers on this face and extra sheets percentage. Each non-omitted grid cell consumes one sheet per layer before extra stock is added.
  4. Calculate and inspect sheet cells and stud segments. Download calculation.csv and layout-plan.json; check the separate framing requirements before buying material.

Example: Drywall and Stud Material Planner

A 4.8 by 2.4 meter wall with one 0.8 meter-wide floor-level opening and 0.4 meter stud spacing.

You add
unit: m; width: 4.8; height: 2.4; sheetWidth: 1.2; sheetHeight: 2.4; layers: 1; spacing: 0.4; stock: 2.4; openings: 1.2 | 0 | 0.8 | 2; waste: 10
You get
5 sheets and 13 stud stock pieces

Supported inputs and limits

  • One wall, up to 40 non-overlapping rectangular openings in at most 10,000 characters, 400 sheet cells, 500 regular stud bays and 2,000 stud segments.
  • Layers run from 1 to 10.
  • Use plain decimal dimensions in the selected unit.
  • A cell fully inside an opening is omitted; a partial cell still consumes a sheet and needs cutting.
  • No offcut reuse is assumed.
More details

Studs inside an opening are trimmed, and full-height edge studs are added.

Each segment consumes one stock piece and must fit the entered stock length; no splicing is modeled.

Plates are reported only as two wall widths of total length.

Headers, trimmers, corner backing, fasteners, structural loads, services and code compliance require a separate design.

This simplified material layout is not a complete framing schedule.

Where your input is processed

This tool does not upload your inputs. See the limits for anything saved on your device.

Questions about Drywall and Stud Material Planner

When does an opening remove an entire sheet cell?

A sheet cell is omitted only when it lies completely inside an opening. A partially intersected cell still consumes one sheet per layer.

How are studs handled at an opening?

Regular studs strictly inside an opening are split around it. Full-height studs are added at the opening edges. Each remaining segment consumes a stock piece.

Does this provide a complete framing schedule?

No. Headers, trimmers, corner backing, fasteners and structural requirements need a separate design. Plate quantity is shown as length only.

Page updated · Project managed by Tony Hines · Report a problem with Drywall and Stud Material Planner